![]() If your gel-cell battery shows a low charge once again, chances are it will need replaced. Retest the gel battery with a voltmeter after the 24-hour period has passed. This will allow the surface charge to dissipate and provide a more accurate reading. Permit the gel battery to sit for 24 hours after charging. A voltage-limited charger will charge at a set rate and turn off when a full charge is achieved. A traditional charger should not be used on gel batteries, as it may overcharge and damage the battery. Be sure that you use a voltage-limited battery charger, also known as a float charger, for this task. Recharge the gel battery if you receive a low voltage reading. The simplest and quickest way to test your gel battery is with a digital voltmeter. This also means gel batteries cannot be tested with a hydrometer. ![]() Gel batteries, however, are generally more expensive than traditional batteries and are not able to be refilled. Because of this, gel batteries are spill-proof and more resistant to corrosion. Rather, silica is added to the electrolytes, causing it thicken into a gel that is suspended within the battery. How to Test Gel BatteriesĪ gel-cell battery is different than most traditional batteries in that it is sealed and does not utilize liquid electrolytes. Disconnect the two clamps on the battery terminals. After 24 hours, your gel battery is fixed, restored and fully charged, so turn off the charger. Then turn on the charger again.Ĭontinue to charge the battery, but check it every six hours to ensure it doesn’t get too hot. If it is warm, that’s fine, so continue charging, but if it feels hot, turn off the charger and let the battery cool for about 30 minutes. Feel the side of the battery after 6 hours. Turn on your charger and then let your battery charge. Plug in your battery charger to the electricity supply.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |